Car Recall Check

A fuse may be faulty, which can lead to engine failure or impairment of the restraint functions and instrument cluster. This increases the risk of an accident, injuries and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

The fixing screws for the turbocharger oil return line and the crankcase breather pipe may have been interchanged. Due to a screw being too long, the pre-tensioning force of the screw connection may be insufficient and oil could leak from the turbocharger oil return line. As a result, oil could come into contact with hot components, increasing the risk of fire.

The adhesive bond between the glass panel and the sliding-roof frame may not meet the specifications. As a result, the glass panel could become completely detached from the vehicle, posing the risk to the following traffic.

Moisture can penetrate into the busbar, giving rise to conductive contacts between the individual lines inside it. The resulting current flows could overheat the plastic material of the busbar, increasing the risk of fire.

The elastomer material of the oil feed line for the exhaust-gas turbocharger may not comply with the specification, allowing oil to leak out.Consequently, the leaking oil could come into contact with hot components, increasing the risk of fire.

The left-hand side, rear seat-back lock does not comply with the specifications. This could lead to a failure of the seat-back locking system in the event of an accident, increasing the risk of injury.

The driver and passenger airbags of the company Takata in vehicles with ammonium nitrate gas generators without drying agents could, under certain climate conditions, lead over time to a chemical change in the fuel.In the event of an accident triggering the release of the driver or passenger airbag, this change could cause the gas generators to burst. If a gas generator ruptures, the airbag would then have no restraining function and loose parts from the gas generator could reach the vehicle interior. This would increase the risk of injury for passengers.

Due to the lack of documentation, there is no confirmation that the screw connections of the turbocharger’s oil-supply and oil-return pipes were correctly executed during the assembly process. In the event of a loose screw connection, oil might leak at the oil-supply and/or oil-return pipe of the turbocharger.The leaking oil might then come into contact with hot components, increasing the risk of fire.

Cracks could occur in the high pressure lines between the fuel rail and the injectors. As a result, diesel fuel could leak into the engine compartment, increasing the risk of fire.Moreover, due to the fuel leak the engine might not start, or the emergency operating mode might be activated.

Due to a defective screw connection, the starter motor positive cable may become damaged by the relative movements of the starter.Consequently, the cable could come into contact with the housing of the starter and cause a short circuit, which could lead to an engine stall and increased risk of fire.

The electrical connector of the side-impact sensors might not be correctly latched and could become detached.This would lead to delayed activation of the restraint systems in the event of a side impact, reducing their restraining effect and increasing the risk of injury to the vehicle occupants.

The belt tensioner arm may have been manufactured with a borderline tolerance, which could cause one side of the V-ribbed belt to rub against the belt tensioner, causing it to fail. As a result, the coolant pump may stop working, causing the engine to overheat, thus compromising the impermeability of the oil sump. Consequently, oil may leak onto the road, posing a risk to the following traffic. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.