Car Recall Check

There may be metal chips in the housing of the airbag control module. This could result in a short-circuit occurring on the circuit board in the airbag control module causing the airbags to deploy unnecessarily.

The thermal protection between the brake force booster and the emissions control device in front of the coupling support with the brake fluid reservoir may not have been correctly fitted. The coupling support could melt, leading to a leak of brake fluid, which could ignite if it comes into contact with hot components. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

In the event of a repair, due to an ambiguous indication in the replacement parts catalogue, the adhesive joint between the sunroof cover and the sliding roof may be fitted incorrectly. As a result, the sunroof cover could detach in motion and endanger the following traffic.

Cars initially used for internal purposes of Volkswagen AG might not have been correctly modified before they were sold to the general public. There is a possibility that certain safety systems of these cars are not correctly modified for street use.

The brake pedal pushrod may be defective.As a result, in case of failure of the electromechanical brake booster, the effort necessary to actuate the brake increases significantly, increasing the risk of an accident.

Volkswagen has been informed by its current supplier that driver-airbag gas generators from the original manufacturer Takata (‘NADI’ (non-azide driver inflator) generators) produced during 1997-1999 may be faulty. VW used these gas generators exclusively in vehicles with a wooden steering-wheel rim (at that time an equipment option). Internal investigations have shown that in the event of an accident the restraining effect of the deployed NADI driver airbag might not always be fully guaranteed. Compliance with the statutory requirements in force for protection by an airbag in the event of an accident is thus not ensured.

The vehicles affected may have been fitted with Takata gas generators which could allow the ingress of moisture and thus result in the degradation of the propellant. If the airbag deploys, this could cause the gas generator to burst, causing metal parts to enter the vehicle's interior, causing injuries to the occupants of the vehicle.

Due to a manufacturing error, the belt-pulley securing ring of the steering system may not be fully engaged. As a result, the securing ring may become detached and subsequently jam with surrounding components, leading to possible locking of the steering system.

The propellant used in the airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event of an airbag being deployed, the excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the occupants.

The push/actuating rod may not be properly screwed onto the brake booster and could become detached.As a result, there would no longer be any mechanical connection between the foot brake and the brake booster.Consequently, braking will be possible only by actuating the regulated emergency-braking function of the electronic parking brake (EPB) using the EPB switch on the central console.

The amount of extinguishing sand in the fuse of the high-voltage system is not sufficient in the event of a short circuit to the high-voltage safety system. This may cause it to burst, increasing the risk of injuries. Furthermore, the blown fuse can interrupt electrical flow of current leading to a voltage drop inside the vehicle, increasing the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

The engine covers installed on affected vehicles could detach from their fixings depending on the conditions of use (e.g. very sporty driving, or poor road surfaces) and their age. A loose engine cover could come into contact with the hot area of the exhaust gas turbocharger, increasing the risk of burns or fire. The product does not comply with the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicle.